Session start

1. You must first connect to the interface at 10.00 PM (Central Europe Time) before the subject is sleeping to make sure that all is fine. A quick test of various features and audio connection must be made prior to start.

2. Verifying contraction sensor: Request the subject to produce anal contractions and verify that these are visible on the graph. Use the Zoom and Rescale features if needed.

3. Verifying microphone: Request the subject to say something e.g 'hello' and verify it can be heard. See below "Audio Settings" paragraph in case of problem hearing the subject.

​

Electro Calibration

The electro-calibration allows determining the various thresholds of the test subjects related to the intensity of the electro-stimulation. This procedure is mandatory prior to activate the sleep mode in order to determine these 3 different thresholds:

• A: The voltage at which the test subject is feeling very light stimulation

• B: The voltage at which the test subject is feeling intense stimulation

• C: The voltage at which the test subject is reaching highest pain limit
  
  To start the electro-calibration, select the "Calibration" tab and click on "Electro-Calibration" button. Then use the relative Calibration button to calibrate each threshold. Watch this video to see the calibration step-by-step:
  
  
  
  
  
  
  
  
  
   

Sleep mode start

1. Once the test is complete, the subject should be put in sleep mode before 10.30 PM using the "Sleep mode" switch.

2. Once in sleep mode, various features are disabled to avoid waking up the subject. During sleep mode, the subject has to be regularly monitored to check its arousal state.

3. Voltage can be very gradually increased and wave forms/treatments can be slowly modified to produce arousal during sleep. Keep the subject under low voltage (~15-25 V) from the beginning of the sleep mode.
   This light stimulation should not prevent the subject to sleep but will contribute to get the subject already habituated to the stimulation during sleep. This way the subject may not wake up when the voltage will be later increased again. Slight variations of voltage and beat frequency while the subject is in phase of getting asleep are helpful to maintain a light sexual arousal and prepare the subject for wet dreams.

4. Intermittently use the InjectronX feature to progressively inject harmonic frequencies in the stimulation signal, this may further increase the subject arousal.

5. An increasing heart rate after a continuous period of low heart rate (<60 bpm) may indicate that the subject entered in REM phase in which sexual dreams are possible and stronger stimulation can be applied. Anal contractions must be carefully monitored as they can be a marker of strong sexual arousal.

One hour after sleep mode start

1. After 1 hour in sleep mode, the subject should ideally be in a REM sleep phase, most features are automatically enabled again under low intensities to allow administrating a larger range of stimulation. However do not use these features if you notice a low heart rate (<60 bpm) which indicates that the subject is still in deep sleep. Instead, please keep slowly increasing the voltage until the heart rate increases and then only use other stimulation features.

2. If the subject is waking up, it can disable the sleep mode so that all features can be used again at higher intensities. Please note that only the subject can disable the Sleep mode so you can request the subject to disable it if subject is awake.

​

Notes:

The session should not extend after 1AM unless otherwise decided with the subject.

​

​